Wilson Roof Pros provides professional skylights in Wilson, NC for residential and commercial properties across the inner Coastal Plain between the Neuse and the Tar. Skylights are harder to place on a hipped roof than on a gabled one, and on some Wilson houses we recommend a tubular daylight device instead. That is not a smaller sale we are being noble about. It is the only thing that fits the geometry without creating a problem.
A skylight wants clear roof above it and to each side, because the flashing kit works by shedding water around the unit and back into the field. On a hipped plane there is no ridge above — there are hips converging from each side to an apex. Put a unit high on a small hipped plane and its head flashing lands within a foot or two of two hips, exactly where you do not want a seam.
So we measure the plane before we talk about product. Where there is genuine room, a deck-mounted unit with the manufacturer's own step and head flashing kit, installed on a self-adhered membrane that is dressed up under the head and out over the sill, is a fifteen-year detail with no drama in it. Where there is not, a tubular device threading between rafters gives most of the light and creates none of the exposure.
Curb-mounted units go on low-slope additions, never on a shallow plane without one. A skylight sitting flush on a three in twelve rear shed roof is a dam, and every one we have opened up in that position has been wet. If you want light in an addition, a curb built to give the unit real fall is the difference between a window and a leak.
Old units are their own decision. A twenty-five-year-old acrylic bubble with a fogged dome and a sealed-in leak is not worth flashing back into a new roof. If the roof is coming off anyway, replace the unit while the deck is open — it is the cheapest hour of that job, and refitting an old skylight into new shingles is how a good roof gets its first leak.
Condensation gets mistaken for a leak constantly. A skylight in a bathroom or over a kitchen in this humidity will run water down the glass in winter and that is not a flashing fault. We check the shaft, the insulation around it and the exhaust before we sell anyone a repair.
Our licensed and insured team brings the right materials and equipment to every job — hip-and-ridge cap counted as hip footage plus ridge footage, off-ridge box vents set two courses down from the peak, net free ventilating area figured against measured attic floor area, a pyramidal roof with no ridge line to cut, site-formed hip caps bent to the roof's own angle, closed-cut valleys where a rear shed ell dies into a hipped plane — and backs the work with a written workmanship warranty. We serve Wilson and nearby communities including Elm City, Black Creek, Lucama, Stantonsburg.
What We Handle
Everything our skylights in Wilson covers
One crew, one point of contact, and the full range of skylights work in Wilson, NC. If it is on this list we do it in house rather than handing it to a subcontractor:
- skylight installation Wilson NC
- skylight repair Wilson
- leaking skylight Wilson NC
- skylight replacement Wilson
- sun tunnel Wilson NC
- solar tube skylight Wilson
- velux skylight Wilson NC
- curb mounted skylight Wilson
- skylight flashing kit Wilson NC
- skylight contractor Wilson County
- skylight glass replacement Wilson NC
- attic skylight shaft Wilson
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Wilson services.
Materials, equipment and how we do skylights
The difference between skylights that lasts and skylights that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with hip-and-ridge cap counted as hip footage plus ridge footage, off-ridge box vents set two courses down from the peak, net free ventilating area figured against measured attic floor area, a pyramidal roof with no ridge line to cut, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Wilson job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the inner Coastal Plain between the Neuse and the Tar means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do skylights outside Wilson
Wilson Roof Pros covers Wilson and the surrounding communities of the inner Coastal Plain between the Neuse and the Tar. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Skylights in Elm City, NC — Wilson County, population 1,218
- Skylights in Black Creek, NC — Wilson County, population 692
- Skylights in Lucama, NC — Wilson County, population 1,036
- Skylights in Stantonsburg, NC — Wilson County, population 762
- Skylights in Saratoga, NC — Wilson County, population 353
- Skylights in Sims, NC — Wilson County, population 275
Start on the Wilson Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Wilson Chooses Wilson Roof Pros
- ✓We record linear feet of ridge and linear feet of hip on every estimate, because cap footage and vent capacity both come from those numbers and a square count tells you neither.
- ✓We refuse ridge vents on roofs that cannot supply them. If the ridge is too short to carry the exhaust an attic needs, we fit off-ridge or hip vents and explain the arithmetic instead.
- ✓We repair sound old metal roofs rather than removing them. Fasteners, seams, rust conversion and a coating system beat a tear-off on most of the older frame houses around here.
- ✓We quote the plane when a plane is what failed. Hipped roofs are bounded by hips, so replacing one slope is straightforward and we would rather do that than sell a whole roof.
The standards behind skylights
Quality here is not a matter of opinion — it is written down. The skylights work we do in Wilson follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every skylights project in Wilson gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free skylights free estimate in Wilson, or request a quote and we'll get right back to you.